The type of wire differentiates gas metal arc welding and flux cord arc welding from one another. Continuous solid wire electrode (GMAW) or a wire that contains materials in its core (FCAW) are used.
- Experts recommend you use a compact 115-V or 230-V-input GMAW wire feeder and welding machine indoors on new, clean steel from 24- to 12-ga. T
- welve-ga. is a little less than 1/8 in. thick, while 24-ga. is less than 1/16 in. thick. The smallest wire (0.025 in.) can make it easier to weld thinner material.
- If you need to weld 1/8- to 1/4-in.-thick material with GMAW, you will need a higher-capacity, compact machine, which requires 230-V input.
- The higher amperage range of this machine can handle your welding needs in a single pass, so you may not have to waste time with second or third passes.
- The 230-V machine also can run 0.035-in.-dia. wire.
- To weld material thicker than 1/4 in., you need a higher-capacity industrial machine.
- If you perform most of your welding indoors on clean material 1/8 in. thick or less, a GMAW machine that operates on 115 V probably is more economical than a 230-V-input machine.
- FCAW. Experts recommend that FCAW be used only on materials no thinner than 20-ga., a bit thicker than the 24-ga. for GMAW.
- In general, this process is best for welding thicker materials with a single pass, especially when welding outdoors.
- With the proper electrode and the right machine, you can weld steel up to 1/2 in. thick.
To read the original article please click:
http://www.thefabricator.com/ArcWelding/ArcWelding_Article.cfm?ID=27 |
